Who Can Competently Cut Down Or Trim Your Tree?

Due to the high strength of the fibers, a healthy tree easily tolerates even strong winds, so special equipment and technologies must be used for cutting and trimming. Experts fromhttps://treeremovalcarlsbad.com/ are definitely familiar with all the nuances of this complicated job.

In addition, it is important not only to saw through the trunk, but also to drop it in the right direction, otherwise there is a high probability of damage to nearby buildings, as well as complication of the whole process.

The cutting technology, as well as the equipment used for this purpose, depend on many factors, therefore, the efficiency and safety of the process directly depend on the correct choice of the cutting/felling method and the technique used for this.

Why are trees being cut?

Here are the main reasons for cutting or felling trees:

• forest restoration;
• sanitary treatment (removal of diseased trees);
• industrial extraction of wood;
• preparation of the site for agricultural use;
• preparation for repair or construction work;
• removal of emergency or potentially dangerous trees.

What is the difference between cutting, chopping and felling?

The term felling appeared at a time when the main tool for extracting wood was an axe. With the advent of first two-handed saws, then gasoline saws, wood chopping was sometimes called sawing. After all, in addition to sawing the trunk, people had to work pretty hard with a hammer.

From the beginning to the middle of the twentieth century, the terms felling /sawing have been synonymous, which mean any method of extracting wood in which the stump, that is, the lower part of the trunk (lump) and the roots remain in the ground.

First, the roots of the tree were dug out and chopped off, then a loop was thrown over the upper part and at the same time they pulled together, that is, they pulled. A concerted jerk of sufficient force caused the roots to come out of the ground, and the tree fell under its weight.

In the XXI century, felling is carried out with the help of heavy machinery, which acts on the trunk using:

• steel cable;
• bulldozer knife;
• armored hull.

Real chopping, in which the trunk is separated from the stump with an axe, is used only in cases where it is impossible to use gasoline or mechanized saws, that is, on hikes and occasionally in garden or suburban areas.

According to the experience of the specialists of tree removal Carlsbad, sawing is the most common way of extracting wood or removing wood, and the felling is used when clearing the territory of small forests (trees 5-15 cm thick) for crops or any other needs.

Nevertheless, all these terms are partially interchangeable, so it is not uncommon for cutting to be called felling or chopping.

Main methods

Manual or mechanized cutting is used to remove trees. Trees are manually removed where it is not possible to use mechanized equipment. Therefore, this method is used in cities and towns, because in order to cut down any tree, it is necessary:

• teams of several people with chainsaws;
• climbing equipment or hydraulic lift;
• tape or shields for fencing the danger zone.

Climbing equipment and fencing can also be used in other jobs, so that the cost of equipment is significantly less than what is required to buy even a small logging machine.

Conclusion

Tree removal is a complex multi–stage process that is carried out both with the help of hand tools and with the involvement of motorized equipment. The speed and safety of the process directly depend on the correct choice of tools and procedure, as well as the qualifications of the performers. Only experts are able to choose the right tool in each specific case and competently cut or trim trees.